Enhancing Broadband

Once the on-site wiring has been completed and the 3 lights on the router are on and steady the router must be configured with the correct connection type, VPI/VCI settings and the account username and password.

This can be achieved in a two different way, firstly using the easy setup wizard built into the router, and lastly by manually uploading a configuration file into the router via the web interface.

Instructions:

Manual Upload:

1. Open your web browser (e.g. Safari / Internet Explorer)

2. In the address bar type in '10.0.0.138' and press Enter

3. This should open the router configuration page as below

4. Click on 'Advanced' menu on the left side of the page

5. Click on 'System'

6. The Configuration window should now be visible as below. Click on 'Choose File'

7. Open the configuration file you wish to upload. This file must have an .ini extension. This file is in the 'Setup Wizard' folder on the Speedtouch CD and the 'fscommand' folder on the Jetstream CD.

8. The path for the configuration file should now be the text box beside the Browse button. Click on 'Upload' to upload the configuration file to the router.

9. The Upload result box will appear. Click on 'Accept'

10. Click on the 'Basic' Menu header of the left side of the page.

11. Click on 'Connections'

12. Click on 'Disconnect' below the username and password boxes

13. Ensure that the Link and State are 'idle' and 'down' respectively. Enter you username and password as supplied by you ISP. Then click on 'Connect' below the username and password boxes. The Link and state should then change to 'connected' and 'up'.

14. Click on 'Save All'.

The Setup should now be complete, you should have 3 green lights on the router and be able to surf the internet.

Copyright of Connectplay Ltd.