Enhancing Broadband

The first part of installing the Speedtouch 510v4 is to correctly connect all required on site wiring. Once the router the been physically installed the router can then be configured with the appropriate profile for your connection.

Packages:

Remove the contents of the Speedtouch 510v4 package. This should contain the Speedtouch 510v4 router, a power supply, an Ethernet cable, a DSL line cable and an installation CD (optional). If you purchased the router in a Jetstream Multi-PC package from XTRA you will also have a double and single ADSL micro-filters.

Alcatel/Thomson Packaging:
 

	510v4 Router	Power Supply
Ethernet Cable	DSL Cable	Setup CD-ROM

Telecom Jetstream Packaging:

	510v4 Router	Power Supply	Ethernet Cable
	DSL Cable	Setup CD-ROM	ADSL Filters

On Site Wiring:

2. Plug in the power adaptor into an available power point and the connector into the back of the router. Press the power button on the front on the router.

3. Plug in the Ethernet cable from any one of the four Ethernet ports on the back of the router into the network card on your computer.

4. Plug in the DSL line cable into the back of the router and the other end either directly into a wall socket or into the modem side of a double filter. All other telephony devices including phones, faxes, Sky digital, monitored alarm systems etc, must also be filtered.

5. Once this is compete you should have 3 green lights on the top of the router.

Speedtouch Setup:
 

PC Instructions: Using Speedtouch CD-ROM Using Jetstream Boradband Self-Install CD-ROM Using Built-in Wizard (Release 4.2 only) Manual upload

MAC Instructions: Using Built-in Wizard (Release 4.2 only ) Manual upload

Copyright of Connectplay Ltd.